Tonearm cable's unnecessary mass acts as a mechanical capacitor, i.e. Weight construction - The lightweight construction will not upset a turntable/tonearm Other techniques, such as keeping the conducting wire as thin as possible,Įxtremephono tonearm cable reduces the negative effects caused by the By reducing impurities through the use of silver instead of copper, and Oxide impurities acting as semiconductor (orĭiode) junctions. Noise is called the Junction Noise (also known as thermal noise), caused by the Reduce the magnitude 'opposite current', the only way is to reduce the mass of the current Opposing current that is caused by the amount of conductor mass. In plain English, when MC cartridge generates a signal, it will face an That its magnetic field opposes the change. Induced in a conductor by a changing magnetic flux will flow in such a direction Self-induced noise caused by Lentz's Law. It is extremely difficult to preserve signals with such small magnitude, as proven in physics that 2 categories of intrinsic noise exist inĮlectrical conductors that will impact this signal. Information is carried by voltages as low as 0.0000001V. At this level, based on a typical S/N ratio of 60dB, the essential music MC cartridges have output as low as 0.1mV, and a coil impedance of 10 to 30 Ohm. Important, as information can never be recreated once it's lost in the first It is all too common to have a $4000 turntable, $3000 tonearm, $2000 cartridge,Īnd a freebie tonearm cable - the first cable in every audio system is the most On 'protection', but Extremphono tonearm cable's primary goal is that of Problems with conventional designs are their mistakes in focusing the priority Right ingredients that support the Extremephono philosophy for correct music Tonearm cable started as a project to build a 'correct' tonearm cable designįor modern high-performance MC cartridges, as none in the market offers all the Tonearm onearm cable Extremephono Tonearm Cable